Optical Encoder (Masso)

45,41

Op voorraad

Beschrijving

Contactless optical quadrature encoders based on a non-mechanical design. By not having any moving parts, the sensors have very high accuracy and very low failure rate. The encoders can be easily mounted in front of your Lathe’s spindle pulley to provide full quadrature encoder signals for multi pass threading.

Wiring and Setup instructions: CLICK HERE

  • High accuracy with no moving parts
  • Easy to mount with no pulley or timing belts required
  • Wide working voltage range 12 to 24VDC
  • Easy mounting using M3 screws

CAUTION: Output signals are 0v for LOW signal and 10v for HIGH signal.

  • High accuracy with no moving parts
  • Easy to mount with no pulley or timing belts required
  • Wide working voltage range 12 to 24VDC
  • Easy mounting using M3 screws
  • WARNING: Connecting the power polarity in reverse will damage the sensor and these sensors will not work in environments where water or dust will get in contact with the sensors.
  • CAUTION: Output signals are 0v for LOW signal and 10v for HIGH signal.

This post is also available in: Engels