CENTROID KP-3 CNC Touch probe

The CENTROID KP-3 CNC Touch probe is designed for Probing (part setup, zero location setup, and CMM type location and measurement of part geometry), component/fixture/work piece setup, inspection and 3D or 2D digitizing/surfacing. The KP-3 CNC Touch probe is made in USA with patented technology. Centroid has developed the KP-3 from its 30 years of probe building knowledge to achieve this affordable, accurate, robust design. Commonly used on Milling Machines, Machining centers, Routers and Turning centers. The KP-3 is a state of the art Kinematic touch probe and is compatible with most any CNC control that has an input for Probes. Acorn to KP-3 connection is a simple 4 wire hookup just follow the schematic. CNC software configuration is simple one button press with the pre configured preset for the KP-3 using the Acorn Setup Wizard. Also compatible with Mach3/4, WinCNC, LinuxCNC, Pathpilot and others.

• Probing directions X+/-, Y+/-, Z-
• Unidirectional repeatability (2 sigma) 0,00153” (1.5 micron)
• Practical use results on a good milling machine 0.00127mm
• Probe deflection force (X,Y) 3 ounce minimum with 40mm stylus
• Probe deflection force (Z) 15 ounce minimum
• Probe body diameter and length D= 1.35” (34.3mm) L= 2.16” (54.9mm)
• Mounting shank diameter and length D= 0.5” (12.7mm) L= 1.47” (37.3mm)
• Stylus mount thread M3 thread
• Power supply required none
• LED status indicator red when triggered (powered by input 1ma)
• Weight of probe and 10mm shank 0.40 lb
• Over travel limit angle (X,Y) +/- 12 degrees from vertical
• Over travel limit (Z-) 0.25” (6.25mm)
• Environmental IP64
• Patented concentric alignment (spindle/tool holder/probe body run out adjustment)

Probe Stylus Size: 2.5mm diameter and 40mm long

centroid_kp-3_cnc_touch_probe

KP-3 to Acorn schematic  S15020.r5